| About |
|---|
| LL9450U/UP are butene co-monomer based linear low density polyethylene which are designed for rotational molding applications. These are UV8 resistance level rotational molding grades which provide a balance of flow and stiffness, good impact strength, toughness and color stability. LL9450UP is a powder form of LL9450U. Typical Applications : LL9450U/UP can be used to produce variety applications such as general molding, toys & play-ground equipment, outdoor storage containers and water tanks.&& |
| Product Description | |
|---|---|
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Good flexibility,High impact resistance,Good color stability,Low density,Butylene copolymer |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.936 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 5.0 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| Compression Molding | 490 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | < -70.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 114 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D, molded | 56 | ASTM D2240 | |
| tensile strength | |||
| Yield, molding | 17.0 | MPa | |
| Fracture, molded | 24.0 | MPa | |
| Tensile strain | |||
| Fracture, molded | 1000 | % | ASTM D638 |
| Bending modulus | |||
| Compression Molding | 600 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Partial Break |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |