| About |
|---|
| Characteristics: ISOTHANE 1085AU product is polyester poly(adipate)ester based thermoplastic polyurethanes. They exhibit excellent transparency, toughness, abrasive resistance, solvent resistance, and UV resistance. These products can be injection molded, blow molded, and extruded.&& |
| Product Description | |
|---|---|
| Supplier | Great Eastern |
| Generic | TPU-酯 |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Good Clarity,Good flexibility,Good wear resistance,Solvent resistance |
| Availabilitys | North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.18 | g/cm³ | ASTM D792 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| 50% strain | 4.14 | MPa | |
| 100% strain | 5.90 | MPa | |
| 300% strain | 12.4 | MPa | |
| tensile strength | 38.0 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 580 | % | ASTM D412 |
| tear strength | 80.0 | kN/m | ASTM D624 |
| Compression deformation | |||
| 23℃，22 hr | 30 | % | |
| 70℃，22 hr | 75 | % |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 85 | ASTM D2240 | |
| Taber abraser | |||
| H-22 Wheel | 15.0 | mg | ASTM D1044 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |