| About |
|---|
| ISOTHANE 3085A-FRC product is polyether based thermoplastic polyurethane containing a halogen-free fire retardant. This product is specifically formulated for wire and cable jacket. It exhibits good toughness, hydrolysis resistance and flame retardant properties. The product can be injection molded, and extruded. Applications: General Injection & Extrusion Wire & Cable Hose, Tube & Profile&& |
| Product Description | |
|---|---|
| Supplier | Great Eastern |
| Generic | TPU-醚 |
| Material Status | Commercial: Active |
| Features | Good flexibility,Hydrolysis stability,Halogen free,Flame Characteristics,V-0 |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.20 | g/cm³ | ASTM D792 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 14.0 | MPa | ASTM D412 |
| 50% strain | 6.00 | MPa | ASTM D412 |
| 300% strain | 9.00 | MPa | ASTM D412 |
| 100% strain | 8.00 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 710 | % | ASTM D412 |
| tear strength | 100 | kN/m | ASTM D624 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 85 | ASTM D2240 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 2.00 mm | V-0 | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature – hot air dryer | 100 | °C | |
| Drying time – hot air dryer | 4.0 to 6.0 | hr | |
| Dew Point – Hot Air Dryer | -40 to -30 | °C | |
| Recommended maximum moisture content | 0.020 | % | |
| Barrel rear temperature | 175 to 185 | °C | |
| Barrel middle temperature | 190 to 200 | °C | |
| Barrel front temperature | 190 to 200 | °C | |
| Nozzle temperature | 185 to 195 | °C | |
| Drying temperature | 100 | °C | |
| Drying time | 4.0 to 6.0 | hr | |
| Recommended maximum moisture content | 0.020 | % | |
| Barrel 1 zone temperature | 175 to 185 | °C | |
| Barrel 3 zone temperature | 185 to 195 | °C | |
| Barrel 5 zone temperature | 185 to 195 | °C | |
| Nozzle temperature | 180 to 190 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |