| About |
|---|
| ISOTHANE 8102 product is impact modified engineering thermoplastic Polyurethanes. It exhibits excellent tensile and flexural strength, toughness, abrasive resistance, good fatigue resistance, solvent resistance, and maintenance of good physical properties under UV exposure. The product can be injection molded and extruded.&& |
| Product Description | |
|---|---|
| Supplier | Great Eastern |
| Generic | TPU |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Good flexibility,High impact resistance,Fatigue resistance,Good Tensile Strength,Good wear resistance,Solvent resistance |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.19 | g/cm³ | ASTM D792 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 77 | ASTM D2240 | |
| Tensile modulus | 1570 | MPa | ASTM D638 |
| tensile strength | 70.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 170 | % | ASTM D638 |
| Bending modulus | 1760 | MPa | ASTM D790 |
| bending strength | 75.0 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃，6.4mm | 1200 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 90.0 | ℃ | ASTM D648 |
| Vicat Softening Temp | 98.0 | ℃ | ASTM D1525 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature – hot air dryer | 90 | °C | |
| Drying time – hot air dryer | 4.0 to 6.0 | hr | |
| Dew Point – Hot Air Dryer | -40 to -30 | °C | |
| Barrel rear temperature | 205 to 215 | °C | |
| Barrel middle temperature | 215 to 230 | °C | |
| Barrel front temperature | 215 to 230 | °C | |
| Nozzle temperature | 220 to 230 | °C | |
| Processing (melt) temperature | 220 to 230 | °C | |
| Mold temperature | 65 to 80 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |