| About |
|---|
| 20516 is a LLDPE injection molding grade which manufactured by gas phase process. This grade is well suited for application requiring good melt flowability during processign and good flexibility of the final items, like clousures and toys alpplications. Features Good melt flowability and good flexibility of the final items, like clousures. Applications Clousures Toys&& |
| Product Description | |
|---|---|
| Supplier | Jam |
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Butylene copolymer |
| Availabilitys | Africa & Middle East |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.922 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 16 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D638 | ||
| Yield, molding | 12.0 | MPa | |
| Fracture, molded | 6.80 | MPa | |
| Tensile strain | |||
| Fracture, molded | 200 | % | ASTM D638 |
| Bending modulus | |||
| Compression Molding | 430 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 无断裂 | ASTM D256-A |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 46.0 | ℃ | ASTM D648 |
| Vicat Softening Temp | 88.0 | ℃ | ASTM D1525 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |