| About |
|---|
| “Jampilen HP500N” is a medium fuidity polypropylene homopolymer for general purpose injection molding applications. Due to its good fow properties, this grade offers easy mold ?lling and short cycle times. Articles produced from “Jampilen HP500N” exhibit good dimensional stability and high stiffness. “Jampilen HP500N” is widely used for injection moldingconsumer goods such as food containers, cool boxes, vacuum fasks, flower pots, toys, garden fumiture and small appliances. In the medical sector, “Jampilen HP500N” is used for 3-part syringes and a wide range of health-care items. Other applications are closures, caps and crates for products. “Jampilen HP500N” is suitable for food contact. Features: Easy mold filling and short cycle times Good dimensional stability High stiffness Homopolymer Typical Applications: Cool boxes, vacuum fasks, flower pots Food containers Garden fumiture Toys 3-part syringes Closures, caps Crates&& |
| Product Description | |
|---|---|
| Generic | PP homopolymerization |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Excellent Processability,Good Dimensional Stability,Quick molding cycle,Food contact compliance,Moderate liquidity,Homopolymer |
| Availabilitys | Africa & Middle East ,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.900 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 12 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 30 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 95.0 | ℃ | ASTM D648 |
| Vicat Softening Temp | 154 | ℃ | ASTM D1525 2 |
| Accelerate oven aging | |||
| 150℃ | 360 | hr | ASTM D3012 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 102 | ASTM D785 | |
| tensile strength | |||
| yield | 34.0 | MPa | ASTM D638 |
| Tensile strain | |||
| yield | 12 | % | ASTM D638 |
| Bending modulus | 1550 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Loading 1 (10 N) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |