| About |
|---|
| “Jampilen HP500P” is a polypropylene homopolymer with good flow properties for injection molding and compounding applications. This grade offers medium-high fluidity, easy mold flling and short cycle times. The final items molded with “Jampilen HP500P” exhibit good dimensional stability and high stiffness. The product is well suited for the production of thin-walled articles and articles with long flow paths. “Jampilen HP500P” is also an excellent polymer base for compounding and masterbatches. “Jampilen HP500P” is suitable for food contact. Features: Easy mold flling and short cycle times Good dimensional stability High stiffness Homopolymer Typical Applications: Thin-walled articles Containers Boxes Toys Household articles Closures and caps Polymer base for compounding and masterbatches&& |
| Product Description | |
|---|---|
| Generic | PP homopolymerization |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Excellent Processability,Good Dimensional Stability,Quick molding cycle,Food contact compliance,Moderate liquidity,Homopolymer |
| Availabilitys | Africa & Middle East ,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.900 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 17 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 30 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 95.0 | ℃ | ASTM D648 |
| Vicat Softening Temp | 154 | ℃ | ASTM D1525 2 |
| Accelerate oven aging | |||
| 150℃ | 360 | hr | ASTM D3012 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 103 | ASTM D785 | |
| tensile strength | |||
| yield | 33.0 | MPa | ASTM D638 |
| Tensile strain | |||
| yield | 12 | % | ASTM D638 |
| Bending modulus | 1550 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Loading 1 (10 N) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |