| About |
|---|
| Product Description | |
|---|---|
| Supplier | INEOS |
| Generic | SBC |
| Material Status | Commercial: Negative |
| Features | Good Rigidity,Excellent Processability,Good Clarity,Good flexibility,Good surface appearance,High elastic,Block Copolymer |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | g/cm³ | ASTM D792 | |
| Melt Volume Rate | |||
| 200℃，5.0kg | 6.0 | cm³/10min | ISO 1133 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Dart impact equipped with measuring instruments | |||
| Total Energy | 2.15 | J | ASTM D3763 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, annealed | 64.4 | ℃ | ASTM D648 |
| Vicat Softening Temp | 90.0 | ℃ | ASTM D1525 2 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| gloss | 164 | ASTM D2457 | |
| Transmittance | |||
| 550 nm | 93.0 | % | ASTM D1003 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 69 | ASTM D2240 | |
| tensile strength | |||
| Yield, 23 ℃ | 33.4 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 23 ℃ | 30 | % | ASTM D638 |
| Bending modulus | |||
| 23℃ | 1800 | MPa | ASTM D790 |
| bending strength | |||
| 23℃ | 54.0 | MPa | ASTM D790 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |