| About |
|---|
| This resin is manufactured to conform to the requirements for unrestricted food contact of AS 2070 Part 1 (1992).&& |
| Product Description | |
|---|---|
| Supplier | Qenos |
| Generic | LDPE |
| Material Status | Commercial: Negative |
| Features | Good flexibility,High liquidity,Quick molding cycle |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.918 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 70 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD | 1.0 to 3.0 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 43 | ASTM D2240 | |
| Tensile modulus | 140 | MPa | ASTM D638 |
| tensile strength | ASTM D638 | ||
| yield | 9.00 | MPa | ASTM D638 |
| fracture | 9.00 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 90 | % | ASTM D638 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | 140 to 160 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |