| About |
|---|
| Ketron® PEEK-GF30 LSG is a Polyetheretherketone (PEEK) product filled with 30% glass fiber. It can be processed by extrusion and is available in Latin America or North America. Typical application: Medical/Healthcare. Primary characteristic: flame rated.&& |
| Product Description | |
|---|---|
| Supplier | Quadrant |
| Generic | PEEK |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good flexibility,Good Dimensional Stability,Good disinfection,Steam sterilized,E-beam disinfection,Biocompatible,Food contact compliance,Radiation disinfection,Ethylene oxide disinfection,V-0 |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.51 | g/cm³ | ISO 1183 |
| Water absorption rate | ISO 62 | ||
| Saturation, 23 ℃ | 0.10 | % | ISO 62 |
| Equilibrium, 23 ℃, 50% RH | 0.050 | % | ISO 62 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 230 | ℃ | ISO 75-2/A |
| Continuous use temperature | 250 | ℃ | |
| Melting temperature | 340 | ℃ | ISO 11357-3 |
| Linear coefficient of thermal expansion | |||
| MD：23~150℃ | 3.0E-4 | 1/℃ | |
| Thermal conductivity coefficient | 0.43 | W/m/K |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | > 1.0E+13 | ohms | IEC 60093 |
| Dielectric strength | 24 | kV/mm | IEC 60243-1 |
| Dielectric constant | |||
| 1 MHz | 3.60 | IEC 60250 | |
| Dissipation factor | |||
| 1 MHz | 2.0E-3 | IEC 60250 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | V-0 | UL 94 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| M-level | 100 | ISO 2039-2 | |
| Tensile modulus | 7000 | MPa | ISO 527-2 |
| tensile strength | |||
| fracture | 87.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| fracture | 3.0 | % | ISO 527-2 |
| bending strength | 155 | MPa | ISO 178 |
| compressive strength | |||
| 5% strain | 155 | MPa | ISO 604 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |