| About |
|---|
| Kingfa PA66-RG301 is a Polyamide 66 (Nylon 66) material filled with 30% glass fiber. It is available in Asia Pacific or North America for injection molding. Important attributes of Kingfa PA66-RG301 are: Flame Rated Flame Retardant Heat Resistant High Strength Typical application of Kingfa PA66-RG301: Electrical/Electronic Applications&& |
| Product Description | |
|---|---|
| Supplier | Kingfa |
| Generic | PA66 |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good Electrical Properties,Low to No Fogging,Flame Characteristics,High Heat Resistance |
| Availabilitys | North America,Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.46 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 0.40 | % | ASTM D995 |
| TD | 0.90 | % | ASTM D995 |
| Water absorption rate | |||
| 23℃，24hr | 0.60 | % | ASTM D570 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 257 | ℃ | ASTM D648 |
| 1.8 MPa, unannealed | 250 | ℃ | ASTM D648 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volumetric resistance | 1.0E+15 | Ω.cm | ASTM D257 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 0.50mm | V-0 | UL 94 | |
| 0.75mm | V-0 | UL 94 | |
| 3.00mm | V-0，5VA | UL 94 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 95 | J/m | ASTM D256 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | 120 | R 级 | ASTM D785 |
| tensile strength | |||
| 23℃ | 155 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 23 ℃ | 2.10 | % | ASTM D638 |
| bending strength | |||
| 23℃ | 220 | MPa | ASTM D790 |
| Bending modulus | |||
| 23℃ | 8800 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 0.079 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |