| About |
|---|
| Kingfa PVC-CT70905 is a Polyvinyl Chloride material. It is available in Asia Pacific or North America for injection molding. Important attributes of Kingfa PVC-CT70905 are: Flame Rated Flame Retardant Eco-Friendly/Green Heat Resistant Low to No Odor/Taste Typical applications include: Electrical/Electronic Applications Engineering/Industrial Parts Wire & Cable&& |
| Product Description | |
|---|---|
| Supplier | Kingfa |
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Features | Flame Characteristics,Low odor,Heat Resistance, Good,Nontoxicity |
| Availabilitys | North America,Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.36 | g/cm³ | ASTM D792 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile strength retention rate | |||
| 168 hr，121℃ | 93 | % | ASTM D638 |
| Elongation retention rate | |||
| 168 hr，121℃ | 85 | % | ASTM D638 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Continuous use temperature | -20.0 to 90.0 | ℃ | ASTM D794 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 1.0E+13 | ohms·cm | ASTM D257 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 1.50-3.00 mm | V-0 | UL 94 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 15 seconds | 77 | ASTM D2240 | |
| tensile strength | 15.5 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 240 | % | ASTM D638 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 60 to 80 | °C | |
| Drying time | 2.0 | hr | |
| Barrel rear temperature | 140 to 160 | °C | |
| Barrel middle temperature | 150 to 170 | °C | |
| Barrel front temperature | 160 to 180 | °C | |
| Processing (melt) temperature | 140 to 160 | °C | |
| Mold temperature | 30 to 50 | °C | |
| Injection speed | 慢to中等 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 23°C |
| 3. 2.0 in/min |
| 4. 50 mm/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |