| About |
|---|
| Kingfa PVC-FT35 is a Polyvinyl Chloride material. It is available in Asia Pacific or North America for extrusion or injection molding. Important attributes of Kingfa PVC-FT35 are: Flame Rated Eco-Friendly/Green Heat Resistant Low to No Odor/Taste Non-Toxic Typical application of Kingfa PVC-FT35: Fabrics/Fibers&& |
| Product Description | |
|---|---|
| Supplier | Kingfa |
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Features | Low odor,Heat Resistance, Good,Nontoxicity |
| Availabilitys | North America,Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.38 | g/cm³ | ASTM D792 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 1.50 mm | V-0 | UL 94 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 15 seconds | 91 | ASTM D2240 | |
| tensile strength | 18.8 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 160 | % | ASTM D638 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 60 to 80 | °C | |
| Drying time | 2.0 | hr | |
| Barrel rear temperature | 150 to 170 | °C | |
| Barrel middle temperature | 160 to 180 | °C | |
| Barrel front temperature | 165 to 185 | °C | |
| Processing (melt) temperature | 150 to 170 | °C | |
| Mold temperature | 175 to 185 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 23°C |
| 3. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |