| About |
|---|
| Product Description | |
|---|---|
| Supplier | Kolon |
| Generic | PP not specified |
| Material Status | Commercial: Active |
| Features | High impact resistance |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.20 | g/cm³ | ASTM D792 |
| Shrinkage rate | 0.20 ~ 0.40 | % | ASTM D955 |
| Fiberglass content | 40 | wt.% | ASTM D2584 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| 3.20 mm，5 mm/min | 140 | MPa | ASTM D638 |
| Bending modulus | |||
| 5 mm/min，3.20 mm | 7,970 | MPa | ASTM D790 |
| bending strength | |||
| 3.20 mm，5 mm/min | 169 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃，6.4mm | 245 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 163 | ℃ | ASTM D648 |
| 20 ℃/min | 163 | ℃ | ASTM D3418 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 0.80 mm | HB | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| injection molding | Nominal value | Unit | Test method |
| drying temperature | 80 ~ 90 | ℃ | |
| Drying time | 2 ~ 4 | hr | |
| Control moisture content | ≤ 0.1 | % | |
| Front cylinder temperature | 235 ~ 255 | ℃ | |
| Mid cylinder temperature | 220 ~ 240 | ℃ | |
| Temperature at the rear of the cylinder | 200 ~ 220 | ℃ | |
| Nozzle temperature | 235 ~ 255 | ℃ | |
| Mold temperature | 40 ~ 80 | ℃ | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |