KRALASTIC® AP-8A

About

Product Description
Supplier	Nippon
Generic	ABS
Material Status	Commercial: Active

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.04	g/cm³	ASTM D792
Melt Flow Rate
220℃，10.0kg	30	g/10min	ASTM D1238
Shrinkage rate	0.40 to 0.60	%	ASTM D955

MECHANICAL	Nominal value	Unit	Test method
tensile strength	44	MPa	ASTM D-638
Tensile strain	20	%	ASTM D638
Bending modulus	2250	MPa	ASTM D790
bending strength	59	MPa	ASTM D790
Rockwell hardness
R-level	113		ASTM D785

IMPACT	Nominal value	Unit
Impact strength of cantilever beam notch
23℃，6.4mm	294	J/m
-30℃，6.4mm	118	J/m

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa	88	℃	ASTM D648
Vicat Softening Temp
10N	107	℃	ASTM D1525

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
Flame retardant level	HB		UL 94

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.