| About |
|---|
| Kraton D1102 A is a clear, linear block copolymer based on styrene and butadiene with bound styrene of 28.5% mass (AU) or 29.5%mass (AS, ASM) from Europe in the physical form(s) identified below in the grade nomenclature: D1102 AS – supplied as porous pellets dusted with silica D1102 AU – supplied as undusted porous pellets D1102 ASM – supplied as powder dusted with amorphous silica Kraton D1102 A is used as an ingredient in formulating adhesives, sealants and coatings. It may also find use as a modifier of bitumen or thermoplastics and in compound formulations.&& |
| Product Description | |
|---|---|
| Generic | SBS |
| Material Status | Commercial: Active |
| Features | Block Copolymer,Inoxidizability |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.940 | g/cm³ | ISO 2781 |
| Apparent density | 0.40 | g/cm³ | ASTM D1895B |
| Melt Flow Rate | |||
| 200℃，5.0kg | 8.0 | g/10min | ISO 1133 |
| Solution viscosity | 900 to 1500 | mPa·s | Internal Method |
| Combined with styrene | Internal Method | ||
| — | 27.5 to 29.5 | % | Internal Method |
| — | 28.5 to 30.5 | % | Internal Method |
| — | 28.5 to 30.5 | % | Internal Method |
| Antioxidant Additive | > 0.14 | % | Internal Method |
| Total Extractables | < 1.0 | % | Internal Method |
| Ash Content | ISO 247 | ||
| AS | < 0.40 | % | ISO 247 |
| ASM | 2.5 to 5.0 | % | ISO 247 |
| AU | < 0.20 | % | ISO 247 |
| Volatiles | < 0.30 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 30 seconds, molded | 70 | ISO 868 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 33.0 | MPa | ISO 37 |
| 300% strain | 2.90 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 880 | % | ISO 37 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. for AU version |
| 3. for AS and ASM version |
| 4. 25%w toluene solution at 25°C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |