KRATON® D1184 K

About
Kraton D1184 K is a clear, branched triblock copolymer based on styrene and butadiene, with a polystyrene content of 31%. It is supplied from North America in the physical form identified below. Kraton D1184 K – supplied as a dusted porous pellet Kraton D1184 KU – supplied as an undusted porous pellet Kraton D1184 KIM – supplied as a dusted powder Kraton D1184 K is used as a modifier of bitumen or thermoplastics and in compound formulations. It may also find use as an ingredient in formulating adhesives, sealants and coatings.&&

About

Kraton D1184 K is a clear, branched triblock copolymer based on styrene and butadiene, with a polystyrene content of 31%. It is supplied from North America in the physical form identified below. Kraton D1184 K – supplied as a dusted porous pellet Kraton D1184 KU – supplied as an undusted porous pellet Kraton D1184 KIM – supplied as a dusted powder Kraton D1184 K is used as a modifier of bitumen or thermoplastics and in compound formulations. It may also find use as an ingredient in formulating adhesives, sealants and coatings.&&

Product Description
Generic	SBS
Material Status	Commercial: Active
Features	Inoxidizability,Copolymer
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.940	g/cm³	ASTM D4025
Melt Flow Rate
200℃，5.0kg	< 1.0	g/10min
Antioxidant Additive	0.15 to 0.40	%	Internal Method
Polystyrene content	29 to 33	%	Internal Method
Total Extractables	< 1.6	%	Internal Method
Ash Content			Internal Method
KIM	4.0 to 6.0	%	Internal Method
KT, talc	0.10 to 0.30	%	Internal Method
Volatiles	< 1.0	%	Internal Method
Solution viscosity
15wt% toluene, 25 ℃	0.90 to 1.3	Pa·s	Internal Method

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw A, 10 seconds, molded	68		ASTM D2240

elastic body	Nominal value	Unit	Test method
tensile strength
yield	27.6	MPa	ASTM D412
300% strain	5.52	MPa	ASTM D412
Tensile strain
fracture	820	%	ASTM D412

Supplementary information	Nominal value	Unit	Test method
Diblock Content	16.0
Styrene/Rubber ratio	31/69

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.