| About |
|---|
| Kraton D1186 B is a clear, branched triblock copolymer based on styrene and butadiene with a polystyrene content of 30%. It is supplied from South America in the physical form identified below. Kraton D1186 BT – supplied as a porous pellet dusted with talc Kraton D1186 B polymer is used as a modifier of bitumen in roofing felt compounds, roads and pipe coating. It may also be suitable for use in formulating adhesives, sealants and coatings and in the modification of polymers.&& |
| Product Description | |
|---|---|
| Generic | SBS |
| Material Status | Commercial: Active |
| Features | Block Copolymer,Inoxidizability |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.940 | g/cm³ | ISO 2781 |
| Apparent density | 0.40 | g/cm³ | ASTM D1895B |
| Melt Flow Rate | |||
| 200℃,5.0kg | < 1.0 | g/10min | ISO 1133 |
| Solution viscosity | 1000 to 1400 | mPa·s | Internal Method |
| Combined with styrene | 29.0 to 31.0 | % | Internal Method |
| Antioxidant Additive | >0.25 | % | Internal Method |
| Total Extractables | < 1.4 | % | Internal Method |
| Ash Content | |||
| BT | < 0.50 | % | ISO 247 |
| Volatiles | < 0.30 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw A, 10 seconds, molded | 74 | ISO 868 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 24.0 | MPa | ISO 37 |
| 300% strain | 3.00 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 800 | % | ISO 37 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |
