KRATON® D1186 E

About
Kraton D1186 E is a clear, branched block copolymer based on styrene and butadiene with bound styrene of 30% mass. It is supplied from Europe in the physical forms identified as follows in the grade nomenclature: D1186 ET – supplied as porous pellets dusted with talc D1186 ES – supplied as porous pellets dusted with amorphous silica D1186 ESM – supplied as powder dusted with amorphous silica Kraton D1186 E polymer is used as a modifier of bitumen in roofing felt compounds, roads and pipe coating. It may also be suitable for use in formulating adhesives, sealants and coatings and in the modification of polymers.&&

About

Kraton D1186 E is a clear, branched block copolymer based on styrene and butadiene with bound styrene of 30% mass. It is supplied from Europe in the physical forms identified as follows in the grade nomenclature: D1186 ET – supplied as porous pellets dusted with talc D1186 ES – supplied as porous pellets dusted with amorphous silica D1186 ESM – supplied as powder dusted with amorphous silica Kraton D1186 E polymer is used as a modifier of bitumen in roofing felt compounds, roads and pipe coating. It may also be suitable for use in formulating adhesives, sealants and coatings and in the modification of polymers.&&

Product Description
Generic	SBS
Material Status	Commercial: Active
Features	Inoxidizability,Copolymer
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.940	g/cm³	ISO 2781
Apparent density	0.40	g/cm³	ASTM D1895B
Melt Flow Rate
200℃，5.0kg	< 1.0	g/10min	ISO 1133
Solution viscosity	1000 to 1400	mPa·s	Internal Method
Combined with styrene	29.0 to 31.0	%	Internal Method
Antioxidant Additive	> 0.14	%	Internal Method
Extractables	< 1.4	%	Internal Method
Ash Content			ISO 247
ES，ET	< 0.40	%	ISO 247
ESM	2.5 to 5.0	%	ISO 247
Volatiles	< 0.30	%	Internal Method

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shore A, 30 seconds	74		ISO 868

elastic body	Nominal value	Unit	Test method
tensile strength
yield	24.0	MPa	ISO 37
300% strain	3.00	MPa	ISO 37
Tensile strain
fracture	800	%	ISO 37

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.