KRATON® G1654 H

About
Kraton G1654 H is a linear triblock copolymer based on styrene and ethylene/butylene. It is supplied from North America in the physical form identified below. Kraton G1654 HU – supplied as an undusted powder Kraton G1654 HS – supplied as a dusted powder Kraton G1654 H is used as a base material for themoplastic elastomer (TPE) compound formulations for a variety of applications. It is also used as a modifier of thermoplastics and bitumen. The inherent stability of SEBS polymers suggests the use of G1654 H in applications that must withstand weathering and high processing temperatures.&&

About

Kraton G1654 H is a linear triblock copolymer based on styrene and ethylene/butylene. It is supplied from North America in the physical form identified below. Kraton G1654 HU – supplied as an undusted powder Kraton G1654 HS – supplied as a dusted powder Kraton G1654 H is used as a base material for themoplastic elastomer (TPE) compound formulations for a variety of applications. It is also used as a modifier of thermoplastics and bitumen. The inherent stability of SEBS polymers suggests the use of G1654 H in applications that must withstand weathering and high processing temperatures.&&

Product Description
Generic	SEBS
Material Status	Commercial: Active
Features	Inoxidizability,Copolymer
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.920	g/cm³	ASTM D4025
Antioxidant Additive	0.040 to 0.10	%	Internal Method
Polystyrene content	30 to 33	%	Internal Method
Total Extractables	< 1.6	%	Internal Method
Volatiles	< 0.40	%	Internal Method
Solution viscosity
Toluene 10%wt，25℃	290 to 490	mPa·s

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shore A, 10 seconds	63		ASTM D2240

elastic body	Nominal value	Unit	Test method
tensile strength
yield	> 27.6	MPa	Internal Method
Tensile strain
fracture	> 800	%	Internal Method

Notes
1. Typical properties: these are not to be construed as specifications.
2. 10%w toluene solution at 25°C
3. Measured on the polymer before hydrogenation.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.