| About |
|---|
| Kraton G1730 M is a clear copolymer based on styrene and ethylene/propylene with a polystyrene content of 21%. It is supplied from North America in the physical form identified below. Kraton G1730 MS – supplied as a dusted pellet Kraton G1730 MO – supplied as a dusted pellet Kraton G1730 M is used as a modifier of polymers. It is also suitable as an ingredient in formulating adhesives, sealants and coatings.&& |
| Product Description | |
|---|---|
| Generic | SEPS |
| Material Status | Commercial: Active |
| Features | Inoxidizability,Copolymer |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.900 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 230℃，5.0kg | 13 | g/10min | ASTM D1238 |
| Antioxidant Additive | 0.030 to 0.10 | % | Internal Method |
| Polystyrene content | 19 to 23 | % | Internal Method |
| Total Extractables | < 1.5 | % | Internal Method |
| Ash Content | |||
| S. Silicon dioxide | < 0.15 | % | Internal Method |
| Volatiles | < 1.0 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 10 seconds | 61 | ASTM D2240 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Dust – O，Organically Dusted | < 0.15 | % | Internal Method |
| Styrene/Rubber ratio | 21/79 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Measured on the polymer before hydrogenation. |
| 3. For G1730 MO Organically dusted |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |