| About |
|---|
| Kynar® resins are fluorinated thermoplastic homopolymers. Kynar® 400 HDC M800 resin is a thermoplastic fluorinated polymer. This product has been designed for Oil & Gas applications.&& |
| Product Description | |
|---|---|
| Supplier | Arkema |
| Generic | PVDF |
| Material Status | Commercial: Negative |
| Features | Homopolymer |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Tensile modulus | 1000 | MPa | ISO 527-2 |
| tensile strength | |||
| yield | 45.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| yield | 15 | % | ISO 527-2 |
| Nominal tensile fracture strain | 40 | % | ISO 527-2 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | ISO 179/1eA | ||
| -30℃ | 11 | kJ/m² | ISO 179/1eA |
| 23℃ | 51 | kJ/m² | ISO 179/1eA |
| Charpy Unnotch Impact strength | ISO 179/1eU | ||
| -30℃ | 无断裂 | ISO 179/1eU | |
| 23℃ | 无断裂 | ISO 179/1eU |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 67.0 | ℃ | ISO 75-2/A |
| Melting temperature | 171 | ℃ | ISO 11357-3 |
| Linear coefficient of thermal expansion | |||
| MD | 1.8E-4 | 1/℃ | ISO 11359-2 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 1.73 | g/cm³ | ISO 1183 |
| Melt Volume Rate | |||
| 230℃，10 kg | 3.00 | cm³/10min | ISO 1133 |
| Melt thermal conductivity | 0.19 | W/m/K | |
| Specific Heat Capacity of Melt | 1600 | J/kg/℃ |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 10°C/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |