Lanufene HBD-5101

About
LANUFENE HDB 5101 is a high density polyethylene resin intended for use primarily in blow molding applications. LANUFENE HDB 5101 combines excellent environmental stress cracking resistance (ESCR) and toughness with good process-ability and melt strength. LANUFENE HDB 5101 is recommended for blow molding of large bottles, pails, containers, water storage drums, and chemical shipping containers where good ESCR and toughness are needed. LANUFENE HDB 5101 can be used in pipes application such as portable water distribution pipes, irrigation pipes, conduit pipes, etc.&&

About

LANUFENE HDB 5101 is a high density polyethylene resin intended for use primarily in blow molding applications. LANUFENE HDB 5101 combines excellent environmental stress cracking resistance (ESCR) and toughness with good process-ability and melt strength. LANUFENE HDB 5101 is recommended for blow molding of large bottles, pails, containers, water storage drums, and chemical shipping containers where good ESCR and toughness are needed. LANUFENE HDB 5101 can be used in pipes application such as portable water distribution pipes, irrigation pipes, conduit pipes, etc.&&

Product Description
Generic	HDPE
Material Status	Commercial: Active
Features	Excellent Processability,Good flexibility,Food contact compliance,Good melt strength,High ESCR
Availabilitys	Africa & Middle East ,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.951	g/cm³	ASTM D1505
Melt Flow Rate			ASTM D1238
190℃，2.16kg	0.15	g/10min	ASTM D1238
190℃，21.6kg	16	g/10min	ASTM D1238
ESCR(Environmental Stress Cracking Resistance)
F50	> 500	hr	ASTM D1693

MECHANICAL	Nominal value	Unit	Test method
tensile strength
limit	31.0	MPa	ASTM D638
Tensile strain
fracture	800	%	ASTM D638
Bending modulus	1130	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	180	J/m	ASTM D256-A

THERMAL	Nominal value	Unit	Test method
Embrittlement temperature	< -70.0	℃	ASTM D746
Vicat Softening Temp	125	℃	ASTM D1525

Process Conditions
Extrusion	Nominal value	Unit	Test method
Melt temperature	180 to 230	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.