| About |
|---|
| Leona™ CR302 is a Polyamide 66 (Nylon 66) product filled with mineral. It is available in Africa & Middle East, Asia Pacific, Europe, or North America. Applications of Leona™ CR302 include electrical/electronic applications and industrial applications. Characteristics include: Flame Rated Conductive Good Dimensional Stability&& |
| Product Description | |
|---|---|
| Supplier | Asahi Kasei |
| Generic | PA66 |
| Material Status | Commercial: Active |
| Features | Good Dimensional Stability,Conductive |
| Availabilitys | Africa & Middle East ,North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.52 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 0.50 | % | ASTM D995 |
| TD | 1.0 | % | ASTM D995 |
| Water absorption rate | |||
| 23℃，50% RH | 1.4 | % | ASTM D570 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 250 | ℃ | ASTM D648 |
| 1.8 MPa, unannealed | 245 | ℃ | ASTM D648 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 36.0 | J/m | ASTM D256 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | 90 | M 级 | ASTM D785 |
| tensile strength | |||
| Yield, 23 ℃ | 128 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 23 ℃ | 3.0 | % | ASTM D638 |
| bending strength | |||
| 23℃ | 191 | MPa | ASTM D790 |
| Bending modulus | |||
| 23℃ | 8800 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |