| About |
|---|
| Product Description | |
|---|---|
| Supplier | SABIC |
| Generic | Polycarbonate |
| Material Status | Commercial: Active |
| Features | Ultra High Viscosity |
| Availabilitys | North America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.2 | ASTM D792 | |
| Shrinkage rate | |||
| 3.2 mm | 0.005-0.007 | % | ASTM D955 |
| Melt Flow Rate | 3.5 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile strain | |||
| fracture | 110 | % | ASTM D638 |
| Rockwell hardness | |||
| R-level | 118 | ASTM D785 | |
| bending strength | 93 | MPa | ASTM D790 |
| tensile strength | |||
| yield | 62 | MPa | ASTM D638 |
| Bending modulus | 2343 | MPa | ASTM D790 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Loss factor | |||
| 60Hz | 0.0009 | ASTM D-150 | |
| 1MHz | 0.01 | ASTM D-150 | |
| Dielectric constant | |||
| 60 Hz | 3.17 | ASTM D150 | |
| Volumetric resistance | 1×10 | Ω.cm | ASTM D-257 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 907 | J/M | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Water absorption rate | 0.15 | % | ASTM D570 |
| Hot deformation temperature | |||
| 1.8 MPa | 132 | ℃ | ASTM D648 |
| 0.45 MPa | 137 | ℃ | ASTM D648 |
| Flame retardant level | HB | UL 94 | |
| UL long-term usage temperature | 115 | ℃ | UL 746B |
| Linear coefficient of thermal expansion | 6.8×10^-5 | 1/℃ | ASTM E831 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |