LIM™ 6041 - SOLIAO

About
LIM6041 liquid silicone rubber is a 2 component Radio – Opaque product formulated with Barium Sulfate. It is used in liquid injection molding of high performance elastomeric parts. The combination of excellent tear strength and very high tensile strength makes this product suitable for a wide variety of applications in medical devices where molded parts can be detected under X-ray due it’s radio opacity. Key Features and Benefits Barium Sulfate filled for excellent radio – opacity Excellent tear strength Convenient 1:1 mix ratio for use with automatic equipment Rapid cure time: 10 to 40 seconds depending upon part size, configuration, and molding temperature Wide range of molding temperatures: 1500C (3020F) to 2050C (4000F) Excellent release from metal molds Potential Applications The combination of excellent tear strength and radio – opacity, it is suitable for applications in medical devices such as wound drain catheters, where molded parts can be detected under X-ray.&&

About

LIM6041 liquid silicone rubber is a 2 component Radio – Opaque product formulated with Barium Sulfate. It is used in liquid injection molding of high performance elastomeric parts. The combination of excellent tear strength and very high tensile strength makes this product suitable for a wide variety of applications in medical devices where molded parts can be detected under X-ray due it’s radio opacity. Key Features and Benefits Barium Sulfate filled for excellent radio – opacity Excellent tear strength Convenient 1:1 mix ratio for use with automatic equipment Rapid cure time: 10 to 40 seconds depending upon part size, configuration, and molding temperature Wide range of molding temperatures: 1500C (3020F) to 2050C (4000F) Excellent release from metal molds Potential Applications The combination of excellent tear strength and radio – opacity, it is suitable for applications in medical devices such as wound drain catheters, where molded parts can be detected under X-ray.&&

Product Description
Supplier	Momentive
Generic	硅橡胶,LSR
Material Status	Commercial: Active
Features	Good stripping performance,Good Tensile Strength,Good tear strength,Fast Cure
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Liquid injection molding

Technical Data
THERMAL	Nominal value	Unit	Test method
Thermosetting components
Component A	按重量计算的混合比: 1.0
Component B	按重量计算的混合比: 1.0

Uncured Properties	Nominal value	Unit	Test method
colour	White
Density	1.19	g/cm³

Cured Properties	Nominal value	Unit
Shore hardness
Shaw’s A	44
tensile strength	7.14	MPa
tear strength	33.9	kN/m

Notes
1. Typical properties: these are not to be construed as specifications.
2. As Molded 30 sec @ 177°C (350°F)
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.