LITEN FL 20 - SOLIAO

About
LITEN FL 20 is a medium density copolymer with broad molecular weight distribution and UV stabilization. It can be used for the manufacture of blown packaging films of recommended minimal thickness of 15 µm. The grade is suitable for blending with PE-LD and PE-LLD films up to 40%. The modified films exhibit improved mechanical properties at lower thickness. Liten FL 20 meets the hygienic requirements on materials and articles intended for contact with foodstuffs according to Regulation (EC) 1935/2004 of the European Parliament and of the Council, as well as according to Commission Regulation (EU) No 10/2011 including changes and additions.&&

About

LITEN FL 20 is a medium density copolymer with broad molecular weight distribution and UV stabilization. It can be used for the manufacture of blown packaging films of recommended minimal thickness of 15 µm. The grade is suitable for blending with PE-LD and PE-LLD films up to 40%. The modified films exhibit improved mechanical properties at lower thickness. Liten FL 20 meets the hygienic requirements on materials and articles intended for contact with foodstuffs according to Regulation (EC) 1935/2004 of the European Parliament and of the Council, as well as according to Commission Regulation (EU) No 10/2011 including changes and additions.&&

Product Description
Generic	MDPE
Material Status	Commercial: Active
Features	Weather resistance is good,Food contact compliance,Copolymer
Availabilitys	Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.938	g/cm³	ISO 1183
Melt Flow Rate			ISO 1133
190℃，2.16kg	0.20	g/10min
190℃，21.6kg	20	g/10min
190℃，5.0kg	1.0	g/10min
ESCR(Environmental Stress Cracking Resistance)
50 ℃, detergent, F50	350	hr	ASTM D1693

IMPACT	Nominal value	Unit	Test method
Charpy Notched Impact Strength			ISO 179
-30℃	5.0	kJ/m²
23℃	14	kJ/m²

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	114	℃	ISO 306

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	56		ISO 868
tensile strength
yield	17.0	MPa	ISO 527-2
Tensile strain
yield	10	%	ISO 527-2
Bending modulus	600	MPa	ISO 178

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.