| About |
|---|
| LOCTITE HYSOL KL 1000-3LX provides the lowest cost of ownership with superior moldability and reliability. This material is designed to achieve JEDEC Level 4 requirements, at 220°C reflow temperature.&& |
| Product Description | |
|---|---|
| Supplier | Henkel |
| Generic | 环氧树脂 |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Flame Characteristics,Baking |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 2.01 | g/cm³ | |
| Spiral flow length | 75.0 | cm | |
| Shrinkage rate | |||
| MD | 0.30 | % | |
| Water absorption rate | |||
| 85℃，7days，85% RH | 0.23 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Bending modulus | |||
| 25℃ | 13200 | MPa | |
| bending strength | |||
| 25℃ | 142 | MPa |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | |||
| 25 ℃ | 1.0E+16 | ohms·cm |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 3.20 mm | V-0 | UL 94 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Extractable ion content | |||
| Chloride | 7 | ppm | |
| Sodium | 4 | ppm |
| Uncured Properties | Nominal value | Unit | Test method |
|---|---|---|---|
| Curing time | |||
| 175℃ | 0.014 to 0.022 | hr | |
| 175℃ | 0.017 to 0.033 | hr | |
| Gelation time | |||
| 175℃ | 0.38 | min | |
| Storage period | |||
| 5℃ | 12 | month |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| < 165℃ | 2.4E-5 | cm/cm/℃ | |
| > 165℃ | 7.0E-5 | cm/cm/℃ | |
| Glass transition temperature | 165 | ℃ | |
| Linear coefficient of thermal expansion | |||
| MD | |||
| Thermal conductivity coefficient | 1.3 | W/m/K | |
| Post curing time | |||
| 175℃ | 4.0 to 6.0 | hr |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Melt Temperature: 347°F |
| 3. Automold |
| 4. Conventional mold |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |