| About |
|---|
| PMC-T373J Black Phenolic is a two-stage, electrical purpose molding material offering excellent mold process-ability and optimized cure cycles. Typical applications include gas meter parts, houseware appliance part and electrical applications, etc.&& |
| Product Description | |
|---|---|
| Supplier | Chang Chun |
| Generic | 酚醛树脂 |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good Electrical Properties,Fast Cure,V-0 |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.42 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 1.2 | % | ASTM D955 |
| Water absorption rate | |||
| 24hr | 0.30 | % | ASTM D570 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 56.0 | MPa | ASTM D638 |
| bending strength | 95.0 | MPa | ASTM D790 |
| compressive strength | 220 | MPa | ASTM D695 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | 34.3 | J/m | ASTM D256 |
| Impact strength of cantilever beam notch | 29 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 170 | ℃ | ASTM D648 |
| Relative temperature index | |||
| Electrical performance | 150 | ℃ | UL 746 |
| Strength mechanical performance | 150 | ℃ | UL 746 |
| Impact mechanical performance | 150 | ℃ | UL 746 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 1.0E+12 | ohms·cm | ASTM D257 |
| Dielectric strength | 11 | kV/mm | ASTM D149 |
| Arc resistance | PLC 6 | ASTM D495 | |
| Compared to the leakage tracing index | PLC 4 | UL 746 | |
| insulation resistance | ASTM D257 | ||
| — | 1.0E+10 | ohms | ASTM D257 |
| — | 1.0E+8 | ohms | ASTM D257 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 2.00 mm | V-0 | UL 94 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. (N) |
| 3. (B) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |