| About |
|---|
| PMC T 375 JX is a wood flour and mineral reinforced phenolic injection moulding compound with improved heat resistance&& |
| Product Description | |
|---|---|
| Supplier | Chang Chun |
| Generic | 酚醛树脂 |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Excellent Processability,Good Electrical Properties,High Heat Resistance,Good wear resistance,Grease resistance,Solvent resistance,Fuel resistance,V-0 |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.51 | g/cm³ | ASTM D792 |
| Density | 1.51 | g/cm³ | ISO 1183 |
| Shrinkage rate | 0.50 to 1.0 | % | ISO 2577 |
| Water absorption rate | |||
| 24hr | 0.16 | % | ASTM D570 |
| 23℃，24hr | 0.16 | % | ISO 62 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| bending strength | 90.0 | MPa | ASTM D790 |
| bending strength | 90.0 | MPa | ISO 178 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 181 | ℃ | ASTM D648 |
| 1.8 MPa, unannealed | 181 | ℃ | ISO 75-2/A |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 2.1E+9 | ohms·cm | ASTM D257 |
| Volume resistivity | 2.1E+9 | ohms·cm | IEC 60093 |
| Dielectric strength | |||
| 2 mm | 13 | kV/mm | ASTM D149 |
| 2 mm | 13 | kV/mm | IEC 60243-1 |
| Arc resistance | 150 | sec | ASTM D495 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 1.00 mm | V-0 | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 40 to 90 | °C | |
| Barrel middle temperature | 40 to 90 | °C | |
| Barrel front temperature | 40 to 90 | °C | |
| Nozzle temperature | 85 to 105 | °C | |
| Processing (melt) temperature | 110 to 120 | °C | |
| Mold temperature | 165 to 195 | °C | |
| Injection speed | Moderate-Fast | ||
| Back pressure | < 1.00 | MPa | |
| Screw speed | 30 to 50 | rpm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |