| About |
|---|
| LUTENE LB7500 is mainly intended for extrusion coating and can be processed uniform thickness and width. LUTENE LB7500 is also noted for the excellent heat stability and has good silicone coating processibility. LB7500 has a good adhesion strength with paper and paper board and excellent neck-in characteristic. LUTENE LB7500 contains no additives.&& |
| Product Description | |
|---|---|
| Supplier | LG Chemical |
| Generic | LDPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Low shrinkage,Good bond |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.918 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 7.5 | g/10min | ASTM D1238 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| water vapor permeability | |||
| 25℃ | 0.00196 | MPa | ASTM D393 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 107 | ℃ | DSC |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D, molded | 43 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| Yield, molding | 8.83 | MPa | ASTM D638 |
| Fracture, molded | 11.3 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, molded | 550 | % | ASTM D638 |
| Bending modulus | |||
| Compression Molding | 196 | MPa | ASTM D790 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |