| About |
|---|
| Description LUTENE® XL8080NRS is a standard version having excellent electrical properties for low and medium voltage power cable insulation. LUTENE® XL8080NRS provides excellent surface finish and outstanding output rates over a broad range of conditions. Applications Cross-linkable polyethylene compound for low medium voltage power cable insulation with rated voltage up to 11kV Specification LUTENE® XL8080NRS meets the property requirement of the following material specifications. AEIC CS8 AEIC CS8 ICEA S-94-649 KSC 3611 IEC 60502&& |
| Product Description | |
|---|---|
| Supplier | LG Chemical |
| Generic | XLPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good surface appearance,Crosslinked |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.920 | g/cm³ | ASTM D1505 |
| The degree of cross combination | > 80 | % | ASTM D2765A |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | > 19.7 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | > 500 | % | ASTM D638 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| The rate of change in tensile strength | |||
| 135℃，168 hr | < 10 | % | ASTM D471 |
| Change rate of ultimate elongation | |||
| 135℃，168 hr | < 10 | % | ASTM D471 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| thermosetting | |||
| Elongation under load: 200 ℃ | < 180 | % | |
| Permanent deformation: 200 ℃ | < 15 | % |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | |||
| 23℃ | > 1.0E+16 | ohms·cm | ASTM D257 |
| Dielectric strength | > 22 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 1 MHz | 2.30 | ASTM D150 | |
| Dissipation factor | |||
| 1 MHz | 3.0E-4 | ASTM D150 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 125 to 135 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 23°C |
| 3. 9.8 in/min |
| 4. 0.2 MPa |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |