| About |
|---|
| Description LUTENE® XL8080NTS is a standard version having excellent electrical properties for medium voltage power cable insulation and has a very low level of contamination. LUTENE® XL8080NTS provides excellent surface finish and outstanding output rates over a broad range of conditions. Applications Cross-linkable polyethylene compound for medium voltage power cable insulation with rated voltage up to 36kV. Specification LUTENE® XL8080NTS meets the property requirement of the following material specifications. ICEA S-94-649 AEIC CS8 KSC 3611 IEC 60502 BS 6622&& |
| Product Description | |
|---|---|
| Supplier | LG Chemical |
| Generic | PE |
| Material Status | Commercial: Active |
| Features | Good Electrical Properties,Crosslinked |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.920 | g/cm³ | ASTM D1505 |
| The degree of cross combination | > 80 | % | ASTM D2765A |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 19.6 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 500 | % | ASTM D638 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile strength retention rate | > 95 | % | ASTM D638 |
| Elongation retention rate | > 95 | ppm | ASTM D638 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| thermosetting | IEC 60811-2-1 | ||
| Elongation under load | < 100 | % | IEC 60811-2-1 |
| Permanent deformation | < 10 | % | IEC 60811-2-1 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | |||
| 23℃ | > 1.0E+16 | ohms·cm | ASTM D257 |
| Dielectric strength | > 22 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 1 MHz | 2.30 | ASTM D150 | |
| Dissipation factor | |||
| 1 MHz | 3.0E-4 | ASTM D150 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 120 to 130 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 23°C |
| 3. 9.8 in/min |
| 4. 0.2 MPa |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |