| About |
|---|
| Product Description | |
|---|---|
| Generic | PA6 |
| Material Status | Commercial: Active |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.14 | g/cm³ | GB 1033 |
| Melt Flow Rate | 26.4 | g/10min | ASTM D1238 |
| Relative viscosity | 2.5 | GB T1632 | |
| Shrinkage rate | 1.3 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Bending modulus | 2204 | MPa | ASTM D790 |
| bending strength | 113 | MPa | ASTM D790 |
| Tensile modulus | 2528 | MPa | ASTM D638 |
| Tensile strain | 32.5 | % | ASTM D638 |
| tensile strength | 73.3 | MPa | ASTM D638 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 10.2 | kJ/m² | ASTM D256 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric constant | |||
| 1MHZ | 3.3 | ASTM D150 | |
| Dielectric loss factor | |||
| 1MHZ | 0.028 | % | ASTM D150 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.82MPa | 53 | ℃ | ASTM D648 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | V-2 | UL 94 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |