| About |
|---|
| MAGNUM™ 3904 Ultra Smooth is a high impact ABS resin for extrusion / thermoforming. This grade, is Trinseo’s lowest particulate (gels) content ABS grade, and is specially recommended for the most demanding surface finish applications. Applications: Automotive Interior Furniture&& |
| Product Description | |
|---|---|
| Supplier | Trinseo |
| Generic | ABS |
| Material Status | Commercial: Active |
| Features | Good surface appearance,High impact resistance |
| Availabilitys | North America,Europe |
| Process Methods | Thermo forming |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.05 | g/cm³ | ISO 1183/B |
| Apparent density | 0.65 | g/cm³ | ISO 60 |
| Melt Flow Rate | |||
| 220℃，10.0kg | 4.7 | g/10min | ISO 1133 |
| Shrinkage rate | |||
| MD | 0.40 to 0.70 | % | ISO 294-4 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | |||
| 4 mm, injection molded | 1820 | MPa | ISO 527-2 |
| tensile strength | |||
| Yield, 4 mm, injection molding | 37.0 | MPa | ISO 527-2/50 |
| Tensile strain | |||
| Yield, 4 mm, injection molding | 2.6 | % | ISO 527-2/50 |
| Bending modulus | |||
| 4 mm, injection molded | 1900 | MPa | ISO 178 |
| bending strength | |||
| 4 mm, injection molded | 58.0 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | |||
| -30 ℃, injection molding | 18 | kJ/m² | |
| 23 ℃, injection molding | 34 | kJ/m² |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, annealed | 97.0 | ℃ | ISO 75-2/A |
| Vicat Softening Temp | |||
| B50 | 97.0 | ℃ | ISO 306 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Burning rate | |||
| 2.0 mm | 40 | mm/min | ISO 3795 |
| Flame retardant level | |||
| 1.50 mm | HB | ||
| 3.00 mm | HB |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 0.079 in/min |
| 3. 3-points |
| 4. This rating not intended to reflect hazards presented by this or any other material under actual fire conditions. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |