| About |
|---|
| CFR210 is a halogen flame retardant compound with UL 94 V0, intended for injection moulding. The product is available in natural (CFR210) but other colours can be supplied on request. APPLICATIONS CFR210 is intended for the injection moulding of electrical component.&& |
| Product Description | |
|---|---|
| Generic | PP not specified |
| Material Status | Commercial: Active |
| Features | Renewable resources,Flame Characteristics,Halogenated,V-0,5VA |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.36 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 5.0 | g/10min | ISO 1133 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 24.0 | MPa | ISO 527-2/50 |
| yield | 25.0 | MPa | ISO 527-2/50 |
| Tensile strain | |||
| fracture | 8.0 | % | ISO 527-2/50 |
| Bending modulus | 2500 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | ISO 179 | ||
| -30℃ | 1.5 | kJ/m² | ISO 179 |
| 23℃ | 2.5 | kJ/m² | ISO 179 |
| Impact strength of cantilever beam notch | |||
| 23℃ | 2.5 | kJ/m² | ISO 180 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 127 | ℃ | ISO 75-2/B |
| Ball pressure test | |||
| 125℃ | Pass | IEC 60695-10-2 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | UL 94 | ||
| 1.60 mm | V-0 | UL 94 | |
| 3.20 mm | V-0 | UL 94 | |
| 2.50 mm | 5VA | UL 94 | |
| Glowing wire flammability index | 960 | ℃ | IEC 60695-2-12 |
| Extreme oxygen index | 28 | % | ISO 4589-2 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 3.0 | hr | |
| Processing (melt) temperature | 210 to 240 | °C | |
| Mold temperature | 30 to 50 | °C | |
| Injection speed | Moderate | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 0.079 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |