| About |
|---|
| Product Description | |
|---|---|
| Supplier | Ginar Technology |
| Generic | PA66 |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Excellent Processability,Good flexibility,Flame Characteristics,Self-lubricating,V-0 |
| Availabilitys | Africa & Middle East ,North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.17 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 2.5 | % | ASTM D955 |
| Water absorption rate | |||
| 24hr | 1.0 | % | ASTM D570 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 37 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 100 | ℃ | ASTM D648 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 0.79 mm | V-0 | UL 94 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 122 | ASTM D785 | |
| Tensile strain | |||
| fracture | 10 | % | ASTM D638 |
| Bending modulus | 3030 | MPa | ASTM D790 |
| bending strength | 117 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| Injection | Nominal value | Unit | Test method |
| Suggested injection volume | Nominal value | Unit | Test method |
| drying temperature | 70 | °C | |
| Drying time | 4.0 | hr | |
| Recommended maximum moisture content | 0.20 | % | |
| Temperature at the rear of the barrel | 250 to 265 | °C | |
| Temperature in the middle of the barrel | 265 to 275 | °C | |
| Nozzle temperature | 260 to 270 | °C | |
| Mold temperature | 60 to 80 | °C | |
| Back pressure | 0.00 to 0.490 | MPa | |
| Screw speed | 80 to 100 | rpm | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |