| About |
|---|
| Selenis Maven MS 110 is a copolyester with a slow crystallisation rate and is suitable for the extrusion of heavy gauge sheets, allowing for thicknesses up to 6mm, without crystallisation occurring. Selenis Maven MS 110 is the most economic solution for flat sheets up to this thickness range, when good clarity, surface gloss, and neutral edge colour are required. Selenis Maven MS 110 is recommended when a combination of decorative capability, enhanced graphics, good impact strength at low temperatures and good chemical resistance to detergents and other household cleaning agents, are essential. Selenis Maven MS 110 is easy to process on standard extrusion lines. Sheets made with Selenis Maven MS 110 may be personalised though different methods of decoration, due to its inherent surface tension. Selenis Maven MS 110 is BPA and styrene free, and is fully recyclable code 1.&& |
| Product Description | |
|---|---|
| Generic | PCTG |
| Material Status | Commercial: Active |
| Features | Good Clarity,Good surface appearance,Renewable resources,Food contact compliance,No BPA,Solvent resistance,low-temperature impact resistance |
| Availabilitys | North America,Latin America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | > 1.39 | g/cm³ | ASTM D792 |
| Apparent density | 0.84 | g/cm³ | |
| Intrinsic viscosity | 0.84 to 0.88 | dl/g | ISO 1628-5 |
| Acetaldehyde | < 1.0 | ppm | ASTM F2013 |
| Color b | < 0.00 | ASTM D6290 | |
| Color L | > 85.0 | ASTM D6290 | |
| Crystallinity | > 48 | % | ASTM D1505 |
| Particle Shape | Cylindrical | ||
| Particle size | 270 to 370 | mg/20 chips | |
| humidity | < 0.20 | % | |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting peak temperature | 225 to 235 | ℃ | ASTM D3418 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | 150 | °C | |
| Drying time | 4.0 to 6.0 | hr | |
| Recommended maximum moisture content | 4.0E-3 | % | |
| Melt temperature | 265 to 275 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Crystalline |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |