| About |
|---|
| MAXAMID™PA66-MOS2 is a Nylon 66 with 2% MoS2 incorporated to provide excellent lubricity which significantly reduces the friction and improves the wear properties of injection molded parts.&& |
| Product Description | |
|---|---|
| Generic | PA66 |
| Material Status | Commercial: Active |
| Features | Low coefficient of friction,Lubricating,Good wear resistance |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.16 | g/cm³ | ASTM D792 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| 23℃ | 82.8 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 23 ℃ | 20 | % | ASTM D638 |
| Bending modulus | |||
| 23℃ | 3450 | MPa | ASTM D790 |
| bending strength | |||
| 23℃ | 138 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 48 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 183 | ℃ | ASTM D648 |
| Melting peak temperature | 259 | ℃ | ASTM D3418 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Recommended maximum moisture content | 0.20 | % | |
| Processing (melt) temperature | 290 to 305 | °C | |
| Mold temperature | 38 to 93 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |