| About |
|---|
| MAXATEL® ACGC15-BK is an Acetal (POM) Copolymer material filled with 15% glass fiber. It is available in North America for injection molding. Primary attribute of MAXATEL® ACGC15-BK: Copolymer.&& |
| Product Description | |
|---|---|
| Generic | Copolymer Polyformaldehyde |
| Material Status | Commercial: Active |
| Features | Copolymer |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | |||
| 230℃，3.80kg | 7.0 to 9.0 | g/10min | ASTM D1238 |
| Ash Content | 13 to 17 | % | ASTM D4218 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| 23℃ | 79.3 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 23 ℃ | 7.0 | % | ASTM D638 |
| Bending modulus | |||
| 23℃ | 4830 | MPa | ASTM D790 |
| bending strength | |||
| 23℃ | 110 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 67 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 149 | ℃ | ASTM D648 |
| Melting peak temperature | 166 | ℃ | ASTM D3418 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 82 | °C | |
| Drying time | 2.0 | hr | |
| Processing (melt) temperature | 182 to 198 | °C | |
| Mold temperature | 82 to 93 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |