| About |
|---|
| MAZMID B 150 is a Polyamide 6 (Nylon 6) product. It can be processed by injection molding and is available in Latin America. Applications of MAZMID B 150 include automotive, electrical/electronic applications, engineering/industrial parts, appliances and furniture. Characteristics include: Flame Rated Good Processability Heat Resistant Impact Resistant Low Viscosity&& |
| Product Description | |
|---|---|
| Generic | PA6 |
| Material Status | Commercial: Active |
| Features | Excellent Processability,High impact resistance,Low Viscosity,High Heat Resistance,V-2 |
| Availabilitys | Latin America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.14 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 235℃，2.16kg | 25 to 35 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD | 1.3 to 1.7 | % | ASTM D955 |
| Water absorption rate | |||
| 23℃，24hr | 1.3 | % | ASTM D570 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 50 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | ASTM D648 | ||
| 0.45 MPa, unannealed | 160 | ℃ | ASTM D648 |
| 1.8 MPa, unannealed | 60.0 | ℃ | ASTM D648 |
| Continuous use temperature | 80.0 | ℃ | |
| Melting temperature | 214 to 220 | ℃ | |
| Linear coefficient of thermal expansion | |||
| MD | 7.0E-5 | 1/℃ | ASTM D696 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 1.0E+15 | ohms·cm | ASTM D257 |
| Dielectric strength | 18 | kV/mm | ASTM D149 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 1.60 mm | V-2 | UL 94 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 120 | ASTM D785 | |
| Tensile modulus | 2800 | MPa | ASTM D638 |
| tensile strength | 70.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | > 50 | % | ASTM D638 |
| Bending modulus | 2800 | MPa | ASTM D790 |
| bending strength | 95.0 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |