| About |
|---|
| The Medalist MD-12100 series are high performance thermoplastic elastomers designed for medical and healthcare applications requiring high elasticity and excellent moldability. Medalist MD-12150 is a medium hardness, low density, translucent grade, available in NAT and colors, which can be sterilized and exhibits excellent adhesion to polypropylene. MD-12150S has lower coefficient of friction than MD-12150.&& |
| Product Description | |
|---|---|
| Supplier | Teknor Apex |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good flexibility,Low liquidity,Smoothness,Good disinfection,Halogen free,Good bond,Lubricating,Elastic,Low density,Radiation disinfection,Solvent resistance,Ethylene oxide disinfection |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.885 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 200℃，5.0kg | 6.0 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 1 second | 52 | ||
| Shore A, 5 seconds | 50 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 4.31 | MPa | ASTM D412 |
| 50% strain | 1.17 | MPa | |
| 100% strain | 1.45 | MPa | |
| 300% strain | 2.17 | MPa | |
| Tensile strain | |||
| fracture | 620 | % | ASTM D412 |
| tear strength | 26.6 | kN/m | ASTM D624 |
| Compression deformation | |||
| 23℃，22 hr | 17 | % | |
| 70℃，22 hr | 30 | % |
| Legal Statement | Nominal value | Unit | Test method |
|---|---|---|---|
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 160 to 177 | °C | |
| Barrel middle temperature | 182 to 204 | °C | |
| Barrel front temperature | 193 to 216 | °C | |
| Nozzle temperature | 182 to 227 | °C | |
| Processing (melt) temperature | 182 to 227 | °C | |
| Mold temperature | 27 to 49 | °C | |
| Injection speed | 中等偏快 | ||
| Back pressure | 0.172 to 0.689 | MPa | |
| Screw speed | 50 to 100 | rpm | |
| Cushion | 3.81 to 12.7 | mm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die C, 20 in/min |
| 3. Type 1 |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |