| About |
|---|
| The Mediprene oil free compounds were developed to address demands for transparent medical thermoplastic elastomer (TPE) grades with a minimum of potential extractables and leachables. The Mediprene OF range, helps to prevent the possibility of oil migrating or leaching out of the material, a key requirement for medical and healthcare-related devices. They are ideal for sensitive medical applications where transparency is also required. Regulatory compliance Representative Mediprene grades have passed cytotoxicity tests according to ISO 10993-5 and are compliant with USP Class VI. Mediprene TPE materials are PVC, silicone and latex free, making them allergen free and a viable alternative to PVC based compounds.&& |
| Product Description | |
|---|---|
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Low extract,Steam sterilized,Good bond,Radiation disinfection,Ethylene oxide disinfection |
| Availabilitys | Asia Pacific,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.890 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，5.0kg | 2.0 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD | 0.80 to 2.0 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 4.00 mm | 90 | ASTM D2240 | |
| Tensile modulus | ASTM D638 | ||
| 100% secant | 5.80 | MPa | ASTM D638 |
| 300% secant | 7.50 | MPa | ASTM D638 |
| tensile strength | 18.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 600 | % | ASTM D638 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tear strength | 69.0 | kN/m | ASTM D624 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Operating temperature | -50 to 125 | ℃ |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Barrel rear temperature | 180 to 230 | °C | |
| Barrel middle temperature | 180 to 230 | °C | |
| Barrel front temperature | 180 to 230 | °C | |
| Mold temperature | 20 to 50 | °C | |
| Barrel 1 zone temperature | 150 to 210 | °C | |
| Barrel 2 zone temperature | 150 to 210 | °C | |
| Barrel 3 zone temperature | 150 to 210 | °C | |
| Barrel 4 zone temperature | 150 to 210 | °C | |
| Barrel 5 zone temperature | 150 to 210 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Unstressed Material |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |