| About |
|---|
| MICROTHENE MN 711-20 is a very high flow, rotational molding powder for general-purpose applications. MN 711-20 can be used to produce a variety of rotomolded objects including toys, containers and liners. MN 711-20 produces parts with smooth inner surfaces and good impact strength. MN 711-20 also provides consistent shrinkage characteristics, good warp resistance and is available as a 35-mesh powder.&& |
| Product Description | |
|---|---|
| Supplier | LyondellBasell |
| Generic | LDPE |
| Material Status | Commercial: Active |
| Features | High impact resistance,High liquidity,Food contact compliance |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.915 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 22 | g/10min | ASTM D1238 |
| Particle Shape | Irregular | ||
| Average particle size | 35 | mesh | |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -34.6 | ℃ | ASTM D746 |
| Vicat Softening Temp | 81.0 | ℃ | ASTM D1525 |
| Melting temperature | 103 | ℃ |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | ASTM D2240 | ||
| Shaw’s D | 49 | ||
| Shore D, 15 seconds | 43 | ||
| tensile strength | |||
| fracture | 9.30 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 610 | % | ASTM D638 |
| Bending modulus | 228 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type IV, 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |