| About |
|---|
| Moldex® QS262D/QCM240 is a Polyolefin material. It is available in Asia Pacific. Primary attribute of Moldex® QS262D/QCM240: Crosslinkable. Typical application of Moldex® QS262D/QCM240: Plumbing/Piping/Potable Water&& |
| Product Description | |
|---|---|
| Supplier | Mitsubishi |
| Generic | 聚烯烃，共挤薄膜用聚烯烃 |
| Material Status | Commercial: Active |
| Features | Crosslinked |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.935 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 120℃，5.0kg | 0.90 | g/10min | ISO 1133 |
| Gel content | |||
| 120℃ | 71 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 54 | ISO 868 | |
| tensile strength | ISO 527-2 | ||
| Yield, 23 ℃ | 16.0 | MPa | ISO 527-2 |
| Yield, 95 ℃ | 6.30 | MPa | ISO 527-2 |
| Fracture, 23 ℃ | 27.0 | MPa | ISO 527-2 |
| Fracture, 95 ℃ | 13.5 | MPa | ISO 527-2 |
| Tensile strain | ISO 527-2 | ||
| Fracture, 23 ℃ | 550 | % | ISO 527-2 |
| Fracture, 95 ℃ | 800 | % | ISO 527-2 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. In Xylene, 20 hr |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |
