| About |
|---|
| The Monprene CP-11100 High Density Series of thermoplastic elastomer compounds, available in NAT or colors, from 40 to 90 Shore A, are designed specifically for consumer product applications requiring a soft, rubber-like feel. Monprene CP-11180 is a medium hardness, high density, filled grade that is suitable for injection molding.&& |
| Product Description | |
|---|---|
| Supplier | Teknor Apex |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good flexibility,Good bond,High density,Solvent resistance,Good coloring |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.15 | g/cm³ | ISO 1183 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| TD, fracture | 11.8 | MPa | ISO 37 |
| TD, 100% strain | 3.10 | MPa | ISO 37 |
| Tensile strain | |||
| TD, fracture | 790 | % | ISO 37 |
| tear strength | ISO 34-1 | ||
| TD | 40 | kN/m | ISO 34-1 |
| MD | 39 | kN/m | ISO 34-1 |
| Compression deformation | |||
| 70℃，22 hr | 49 | % | ISO 815 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 5 seconds | 80 | ISO 868 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Apparent viscosity of melt | |||
| Capillary，@ 206/s，200℃ | 218 | Pa·s | ASTM D3835 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel rear temperature | 160 to 177 | °C | |
| Barrel middle temperature | 182 to 204 | °C | |
| Barrel front temperature | 193 to 216 | °C | |
| Nozzle temperature | 182 to 227 | °C | |
| Processing (melt) temperature | 182 to 227 | °C | |
| Mold temperature | 27 to 49 | °C | |
| Injection speed | Moderate-Fast | ||
| Back pressure | 0.172 to 0.689 | MPa | |
| Screw speed | 50 to 100 | rpm | |
| Cushion | 3.81 to 12.7 | mm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Method Ba, Angle (Unnicked) |
| 3. Type A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |