Moplen EP332K - SOLIAO

About
Moplen EP332K Moplen EP332K is the polypropylene block copolymer manufactured by PMC under the license of Basell using the Spheripol process. Moplen EP332K is a block copolymer selected by customers for use in injection molding of Toy, Crates. Moplen EP332K resin meets the FDA requirements in the Code of Federal Regulations in 21 CFR 177.1520 for food contact.&&Moplen EP332K Moplen EP332K is a polypropylene impact copolymer with an optimized balance of stiffness and toughness, high impact strength at low temperature, low warpage and good thermal ageing stability. Typical customer applications are injection molding of toys, crates, appliances housing, and general housewares.&&

About

Moplen EP332K Moplen EP332K is the polypropylene block copolymer manufactured by PMC under the license of Basell using the Spheripol process. Moplen EP332K is a block copolymer selected by customers for use in injection molding of Toy, Crates. Moplen EP332K resin meets the FDA requirements in the Code of Federal Regulations in 21 CFR 177.1520 for food contact.&&Moplen EP332K Moplen EP332K is a polypropylene impact copolymer with an optimized balance of stiffness and toughness, high impact strength at low temperature, low warpage and good thermal ageing stability. Typical customer applications are injection molding of toys, crates, appliances housing, and general housewares.&&

Product Description
Supplier	LyondellBasell
Generic	PP copolymer
Material Status	Commercial: Active
Features	Good Rigidity,Low warping,Good heat aging resistance,Good flexibility,High impact resistance,Food contact compliance,Block Copolymer,Ultra high toughness,low-temperature impact resistance,Impact copolymer
Availabilitys	Africa & Middle East ,Asia Pacific
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.900	g/cm³	ASTM D1505
Melt Flow Rate
230℃，2.16kg	5.0	g/10min	ASTM D1238

MECHANICAL	Nominal value	Unit	Test method
tensile strength
Yield, injection molding	24.5	MPa	ASTM D638
Tensile strain
Yield, injection molding	9.0	%	ASTM D638
Bending modulus
injection molding	1130	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23 ℃, injection molding	150	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed, injection molded	88.0	℃	ASTM D648

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.