| About |
|---|
| Moplen HP425J Moplen HP425J is a Polypropylene Homopolymer (PP Homopolymer) material. It is available in Asia Pacific. Important attributes of Moplen HP425J are: Food Contact Acceptable Good Aesthetics Good Processability Homopolymer Typical applications include: Coating Applications Film Food Contact Applications&&Moplen HP425J Moplen HP425J is a modified polypropylene homopolymer containing a Calcium Stearate free stabilization package. It does not contain any slip or antiblocking additives. Moplen HP425J is designed for the high speed production of BOPP films. It is used by customers for a broad range of applications including metallizable films and both plain and coextruded structures. BOPP films produced with Moplen HP425J exhibit balanced mechanical properties, good transparency, gloss and enhanced shrinkage properties. For regulatory information please refer to Moplen HP425J Product Stewardship Bulletin (PSB).&& |
| Product Description | |
|---|---|
| Supplier | LyondellBasell |
| Generic | PP homopolymerization |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Optical performance,Food contact compliance,Good Tensile Strength,Block resin,Homopolymer |
| Availabilitys | Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.900 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 3.0 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23 ℃, injection molding | 39 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed, injection molded | 102 | ℃ | ASTM D648 |
| Vicat Softening Temp | 152 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 95 | ASTM D785 | |
| tensile strength | |||
| Yield, injection molding | 34.3 | MPa | ASTM D638 |
| Tensile strain | |||
| Yield, injection molding | 12 | % | ASTM D638 |
| Bending modulus | |||
| injection molding | 1470 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 0.20 in/min |
| 3. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |