| About |
|---|
| Moplen X30S is a homo-polymer particularly suited for the extrusion of cast and water quenched blown film. Moplen X30S exhibits excellent process ability and outstanding optical properties. This make Moplen X30S particularly suitable for film for packaging of flowers, books, stationery, blankets, shirts, knitwear, hosiery and food-stuffs such as pasta, snakes, biscuits, bakery products and confectionery. Moplen X30S is also very appropriate for the extrusion of small pipes and drinking straws. Moplen X30S can be used for lamination with polyester, polyamide and aluminum for packaging of snacks, crisps, sweets, coffee, meat products and pre-cooked foods. In these applications, Moplen X30S gives an excellent high gloss finish in laminates and exhibits good printability after corona treatment. * Moplen X30S is suitable for food contact.&& |
| Product Description | |
|---|---|
| Supplier | LyondellBasell |
| Generic | PP homopolymerization |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good surface appearance,Optical performance,Good Printability,Food contact compliance,Homopolymer |
| Availabilitys | Africa & Middle East |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | |||
| 230℃，2.16kg | 8.0 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 36 | J/m | ASTM D256 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Oven Aging | |||
| 150℃ | 15.0 | day | ASTM D3012 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 93.0 | ℃ | ASTM D648 |
| Vicat Softening Temp | 154 | ℃ | ASTM D1525 2 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 93 | ASTM D785 | |
| tensile strength | |||
| yield | 36.0 | MPa | ASTM D638 |
| Tensile strain | |||
| yield | 12 | % | ASTM D638 |
| Bending modulus | 1550 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Loading 1 (10 N) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |