| About |
|---|
| Multi-Flex® TPE A1540 is a Thermoplastic Elastomer (TPE) product. It is available in Africa & Middle East, Asia Pacific, Europe, Latin America, or North America. Primary characteristic: uv resistant.&& |
| Product Description | |
|---|---|
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Soft,Good coloring |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.06 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 27 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shaw’s A10sec | 15 | ASTM D2240 | |
| tensile strength | 2.4 | MPa | ASTM D412 |
| Tensile strain | 870 | % | ASTM D412 |
| tear strength | 65.0 | lbf/in | ASTM D624 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 60 | °C | |
| Drying time | 2.0 | Hr | |
| Injection temperature | |||
| Rear barrel temperature | 170 | °C | |
| Central temperature of the barrel | 175 | °C | |
| Barrel front temperature | 180 | °C | |
| Die temperature | 190 | °C | |
| Mold temperature | 25-30 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |